|
|
Telephone Record Control
This circuit will allow you to connect any tape recorder that has a mic and remote
input to a phone line and automatically record both sides of a conversation when ever the
phone is in use. You will need to take a couple of voltage readings before
connecting the circuit. First determine the polarity of your phone line and connect it to
the circuit as shown and then determine the polarity of the remote input and connect it to
the circuit. Circuit operation is as follows. When the phone is on hook the voltage across
the phone line is about 48volts dc. When the phone is off hook the voltage will drop to
below 10volts dc. When the line voltage is at 48volts the FET is off which causes Q2 and
Q3 to be off. When the phone is picked up the FET turns on along with Q2 and Q3 which
turns your recorder on. The tape recorder must be in the record mode at all times. As you
can see the power source for the circuit is the phone line.
Presiona el botón para volver al menú
