|
|
Tri-Waveform Generator
The Tri-Waveform Generator can be used for a number of different uses. The one that I use it for is a signal generator to test circuits. The frequecy range is 20 to 20khz. and can be adjusted by R1. The duty cycle or the time that the waveform is high and the time that the waveform is low can be adjusted by R4. The purpose of R2 and R3 are to clean up any distortion on the sinewave output. To do this you must hook up the sinewave output to and oscope and adjust R2 & R3 to make the sine wave as accurate as possible.
Presiona el botón para volver al menú
